Heath Zenith SL-5503 Manuel d'utilisateur télécharger pdf

598-1138-02

❒ Attach the cover plate to the junction box (Apply silicon

caulk between cover plate and junction box for a raintight

seal). Keep the ﬁ xture horizontal (within +/- 4°) so the bulb

inside is horizontal. If the bulb is not horizontal, the bulb

may darken or shatter and fail prematurely.

❒ Loosen the side bolt connected to the arm to aim the ﬁ xture

up and down.

Bulb Installation and Relamping

Important: Use a clean glove or cloth when handling the

new bulb. Oil from your hand may cause the bulb to crack

when the ﬁ xture heats up and result in premature failure.

Use isopropyl (rubbing) alcohol to clean the bulb if it is

touched with your bare hands.

❒ When relamping, turn power off and let the ﬁ xture cool.

❒ Remove glass cover and remove the old bulb by pushing

the bulb towards the right until the left side of the bulb is

clear of the left socket.

❒ To insert the new bulb push the bulb into the right socket

so the bulb is properly seated in the sockets.

❒ Re-install the glass cover.

❒ Reconnect the power.

Quartz Halogen Floodlight

Model SL-5503 - 300 Watts

Model SL-5505 - 500 Watts

Fixture Installation Instructions

To avoid Electrical Shock:

The Heath

/Zenith Quart Halogen Floodlight disperses light over a wide area. It includes a halogen lamp, attaches to a

standard threaded junction box cover plate and is for use with 120 VAC.

FOR PROPER INSTALLATION AND OPERATION, PLEASE READ THESE INSTRUCTIONS CAREFULLY.

To Avoid Fire Or Burn Hazards:

• Allow ﬁ xture to cool before touching. The bulb and the ﬁ xture operate at high temperatures.

• Keep ﬁ xture at least 2” from combustible materials. Do not aim at objects closer than 3 feet.

• Use a lamp that does not exceed the maximum ratings for your model.

Maximum ratings are: SL-5503 - 300 Watts; SL-5505 - 500 Watts.

WIRING FIXTURE

(Product May Vary from Illustration)

White to White

Black to Black

Fixture ground to

junction box ground.

Cover Plate

No Service Parts Available for this Product

WARNING: Turn power off at the circuit breaker or

fuse.

• Follow all warnings listed on ﬁ xture.

• Grounding and installations must comply with local codes

and the National Electric Code.

• This product should be mounted on a grounded junction

box and must be used with a threaded cover plate.

• Permanently mount the ﬁ xture to a building or pole.

Fixture is designed for WALL MOUNT ONLY (see illus-

tration below).

❒ Thread aiming arm through the cover plate (not included) and

tighten the locknut. Apply silicon caulk for a raintight seal.

❒ Connect the lamp wires to the power source wiring. Secure

with wire connectors.

1 2 3 4

Résumé du contenu

Page 1 - Quartz Halogen Floodlight

598-1138-02❒ Attach the cover plate to the junction box (Apply silicon caulk between cover plate and junction box for a raintight seal). Keep the ﬁ xt

Page 2 - Faro Halógeno de Cuarzo

598-1138-02❒ Fije la placa cubertora a la caja de empalme (Aplique calafa-teo de silicona entre la placa cubertora y la caja de empalme para obtener u

Page 3 - Projecteur halogène au quartz

598-1138-02❒ Fixez la plaque de couverture à la boîte de jonction (appli-quez un trait de calfeutrant au silicone entre la plaque et la boîte pour ass

Page 4 - GARANTIE LIMITÉE DE 5 ANS

598-1138-02FIVE YEAR LIMITED WARRANTYThis is a “Limited Warranty” which gives you speciﬁ c legal rights. You may also have other rights which vary fro

Commentaires sur ces manuels

Pas de commentaire

Heath Zenith SL-5503 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Non Heath Zenith SL-5503. Heath Zenith SL-5503 User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Heath Zenith SL-5503