Heath-zenith Instant Motion Sensor Light Control SL-5211 Manuel d'utilisateur télécharger pdf (Page 2)

595-4238-07

INSTALLATION

❒ Before proceeding with the installation, TURN OFF

THE POWER TO THE LIGHTING CIRCUIT AT THE

CIRCUIT BREAKER OR FUSE BOX to avoid electrical

shock.

There are two types of decorative fixtures that the Instant Light

Control should be used with as shown here.

‘A’ shows a fixture with the wire going under the top cover. ‘B’

shows a fixture with a open bottom and the wire going through

the bottom.

❒ Open the top of the light

fixture if it is necessary.

Remove the light bulb.

Screw in the lamp module

and replace the bulb.

NOTE: The Drip Loop is neccessary to prevent rain from

running down the cord to the Sensor Module.

❒ Plug the sensor cord into the switch module. The sensor

cord's plug is polarized for proper installation.

❒ Mount the sensor approximately five feet above the ground.

Place the sensor below or beside the lighting fixture

so that the light from the decorative fixture will not hit

the sensor. Secure the sensor to the wall with the screws

provided. It may be necessary to tilt the sensor head up

slightly when mounting.

NOTE: Mounting the sensor above the light fixtures may

increase false triggering.

Drip Loop

Mounting Sensor

IMPORTANT: When installing the sensor, make sure the wire

comes out the bottom of the bracket and the wire has a drip

loop (as shown below) to help prevent water from entering the

sensor head.

Seal With Weather-

Proof Sealant

Drip

Loop

‘A’

‘B’

Drip Loop

‘B’

1 2 3 4 5 6 7 8

Pas de commentaire

Heath-zenith Instant Motion Sensor Light Control SL-5211 Manuel d'utilisateur Page 2